another efe project

by **FBJ admin** » Sat Oct 18, 2014 10:46 am

You can see the wires and connectors are pretty rough

by **FBJ admin** » Sat Oct 18, 2014 10:48 am

I only hung the wiring in the ultrasonic cleaner, using the correct product the outcome was awesome. I only left it in for about a minute

by **FBJ admin** » Sat Oct 18, 2014 10:50 am

I'm after a set of efe indicators if anyone can help. I also need the rear section of the efe mudguard.

Thanks

by **FBJ admin** » Sat Oct 18, 2014 6:35 pm

Today has been good, got lots done to the old girl today, front master cyl cleaned prepped and painted with Satin black, looks sweet too, Also sorted a couple of the elecrics back plates, they are also painted nice.
List still to do:
Add fork oil to legs
3 piece front bralke hose (still to buy)
Sort ignition out (may have to buy one)
Stripe, clean, tape wiring harness, then fit it.
Get a battery (still to buy)
Fit CAS, going for 530, may even try a 520. if 530 will be 17/43 (still to buy) need to align it.
Fit rear brake hose (still to buy)
Fit all bits back inti the tank
Fit carbs, after ultrasonic cleaning. Can't decide wether to stick with a stock air box.
Fit a 170 rear tyre (still to buy)
Fit new clutch centre bearing and new clutch springs,
Replace and fit all casing gaskets.
Set tappets.
New oil and filter.
Fit nice shiny harris
I think I'm about £500 away from done.

by **FBJ admin** » Mon Oct 27, 2014 8:10 am

Got a bit more done on the wiring, I like doing wiring. My ultrasonic cleaner is awesome

by **quexpress** » Wed Nov 05, 2014 12:20 am

FBJ admin wrote:Got a bit more done on the wiring, I like doing wiring. My ultrasonic cleaner is awesome

Quite interesting!
What solution do you use for your wire harness? Once they are cleaned, what do you do to make sure they are dry?
Thanks!

by **FBJ admin** » Wed Nov 05, 2014 6:42 am

Hi. Spray all the connectors with water dispersent. Then hang in the airing cupboard

by **quexpress** » Thu Nov 13, 2014 4:43 pm

FBJ admin wrote:Hi. Spray all the connectors with water dispersent. Then hang in the airing cupboard

Thank you!

by **FBJ admin** » Sat Dec 06, 2014 6:39 pm

Had a few good days. Both brakes fitted with new goodridge hosing, calipers stripped and rebuilt both bled up nice. Harris 4 into 1 fitted. Its one of them projects that will all of a sudden be complete

by **FBJ admin** » Mon Dec 15, 2014 10:37 am

Been busy getting the EFE ready for the Newark show, 3rd an 4th Jan.