My new turbo Kat project

by **FBJ admin** » Wed Nov 20, 2013 1:35 pm

This one is alloy for my top yoke centre bolt

by **FBJ admin** » Mon Jan 20, 2014 12:53 pm

Ouch! It's at the painters now, collecting it in two weeks, he was very pleased the chequers didnt get damaged.

by **FBJ admin** » Tue Feb 18, 2014 7:39 am

The chains on at last, the chain was very expensive. I thought I better have a good one because of the turbo. It fits, it's inline and doesn't fail on anything, result.

by **FBJ admin** » Tue Feb 18, 2014 7:40 am

I also got the front brakes all connected up, just need brake pades and I can bleed them, I got a pair from ebay last night for £27, result.

by **FBJ admin** » Tue Feb 18, 2014 7:42 am

Little Jack, my lad was trying to find fittings for the turbo feed and return, because I have no idea what size they are, I know I need dash 4 hosing for the feed and dash 8 for the return. I might take it to Pirtec and see if they can help.

by **FBJ admin** » Tue Feb 18, 2014 7:43 am

I hope to fit the lock up one night this week. Mr Grumpy will hopefully be dropping of a couple of clutch cover gaskets. The lock up has the drain port in it.

by **FBJ admin** » Thu Feb 20, 2014 7:44 am

Big thanks to FBM, he welded this fitting on to the lock up spacer plate so I can use it for my turbo drain.

by **FBJ admin** » Thu Feb 20, 2014 7:46 am

Had this block welded on so I can mount the rear master cylinder.

by **busa ash** » Thu Feb 20, 2014 11:07 am

FBJ admin wrote:Big thanks to FBM, he welded this fitting on to the lock up spacer plate so I can use it for my turbo drain.

very nice , cool build fbj

by **spondonchris** » Thu Feb 20, 2014 11:33 pm

Not too far off finished now then John. Will be good to see the bike done at Manchester