Page 1 of 1
con rods
Posted:
Wed Feb 26, 2014 4:45 pmby ET 1260 Kitkatman
Hi, Could someone tell me what the letters mean that are cast onto the conrods}A O O 1or4or6. The rods have 20mm gudgeon pins .Also is the taper on the end of the crank different between ET and EFE .Is it possible that I have EFE rods on an ET crank.Any info welcome. Thanks.
Re: con rods
Posted:
Wed Feb 26, 2014 5:30 pmby FBJ admin
Hi not sure on nimbers i know Kats have 493 rods. I think they are the best. The kat crank has a diffent taper to the et. Not sure about ET to Efe.
Re: con rods
Posted:
Wed Feb 26, 2014 9:47 pmby FBJ admin
You could also check the number of teeth. The gear on the crank that spins the clutch is different on the efe and the et
Re: con rods
Posted:
Fri Feb 28, 2014 4:22 pmby ET 1260 Kitkatman
When you say (493) .What does this refer too. Thanks.
Re: con rods
Posted:
Fri Feb 28, 2014 6:42 pmby Duckndive
ET 1260 Kitkatman wrote:When you say (493) .What does this refer too. Thanks.
No,s on the rods
Re: con rods
Posted:
Fri Feb 28, 2014 6:44 pmby FBJ admin
Im not sure if they mean anything more than kat rods. Sorry
Re: con rods
Posted:
Sun Mar 02, 2014 8:13 pmby ET 1260 Kitkatman
Thanks everyone, came to the conclution I have EFE rods on an ET crank.
Re: con rods
Posted:
Mon Mar 03, 2014 10:45 amby Duckndive
ET 1260 Kitkatman wrote:Thanks everyone, came to the conclution I have EFE rods on an ET crank.
Is it fully welded "all round" or part welded "just one stich weld per pin" ?
And does it have a straight cut gear or helical one ?
Re: con rods
Posted:
Wed Mar 12, 2014 11:03 amby ET 1260 Kitkatman
Bought the crank in this condition,polished,welded & balenced.straight cut primary. Just curious as to what i have.